Plywood floor to tile over?
I need a Plywood floor to tile over. Bunnings have a 21 and 17mm. Do I need to use 21mm? what do the bearers need to be set at to…
Removing rock to lay turf
I have an old rock retaining wall in the middle of my lawn that now needs to have lawn at the top of the walls current height. The wall is…
Narrow Bathroom
you can make your wall 70mm instead of 200mm if that helps.
Quality and spare parts of Chinese made toilets
$200 ceramic systems from Bunnings, no issues so far, cant even buy a ceramic seat seperatly for that price.
Butt Welding 150x50x2 RHS Bearers???
** I am not an engineer, but i also don't trust your engineer.
30 meter span, far out,
I am spanning 6 meters with no load and I need 250 C section.
You…
Building in underneath a deck
Fall will be going towards the left, where the slats are, that will be cladding.
https://1drv.ms/i/s!AuneGdR1T9lQg4NyOvEMqgcifB7HWw
Funny Dunny?
Here is the setup, see the access pipe on the top right, i undid this to confirm if this made a different, it did not.
https://1drv.ms/i/s!AuneGdR1T9lQg4Nzi_RRYVdhj-MS8A
Funny Dunny?
well funny you mention, I was on the roof yesterday, there is a ventilation pipe, looks in good condition.
But if you see my other post I have some knocking issues.…
Funny Dunny?
Hi,
My toilet (normal Australian Caroma bowl) has water sitting in the bottom. When it flushes it ends up with the water in the bottom being half full. If I pee…
cost for total renovation
I agree your costs are too low, are you doing the work yourself?
Restump, not enough info and i have only done raises, but this seems low.
deck $10k - what about…
Extension, where to start
You can draw up and measure up and then quote yourself based on Bunnings prices, add a couple of thousand for misc. add your draftsman and council costs, then double…
Taps - water hammer - how to stop
how do I stop a house that knocks when any tap is turned off?
Firstly I turned the pressure down at the mains (this may have helped a bit).
Then I turned…
Strengthen a deck
This is a different deck to my other deck question.
I have an existing deck. The joists are simply 2 pieces of pine glued onto of each other spanning 3 meters.…
Building in underneath a deck
How do i best protect a ceiling built underneath a deck? Does anyone have some photos to share?
The difficult thing is I was hoping to fully clad up the side…
Replacing wooden house posts with steel - what gauge?
Hi, I need to replace existing wooden posts (like the power poles), with steel posts on a single story qlder. Some of the house has new posts (75*75*?), but for…