I would keep the original design and swap the fridge and wall oven positions, I wouldn't like people coming around the corner and running into the oven being opened.
Plan 2…

I have a Rinnai close coupled solar hot water in Melbourne that is less than a year old and it has had many problems . The first cold day in…

Hi
You need to have the water flowing fast for the heater to keep heating, if the water flow is too slow the heater will cut out and then you get…

If there is an opening window at the top of the void it would help a little to let the heat out and make the area slightly better though you…

At least if you use Hogs Bristle you can see many examples of how it will look in actual rooms.
Using other colours are a bit more of a gamble not…

I like the look of Hogs Bristle but I'm bored with seeing it in so many homes. I am thinking of using Dulux Tuft in my large light rooms and…

Thanks Homeangels, the electric winders are very expensive but the manual ones on that website look interesting. I will contact them and see if they are suitable.

I have high windows in the house that I am building that are 3500 above floor level and the supplier Dowell don't have any electric or manual options that will…

I'm very new to all this, if my son was here I would get him to put the link in for me which has made me very lazy about learning…

The deck looks good there is hardly any shading, it looks like a nice spot to sit outside on a sunny winters day.
I stayed at a house in Adelaide that…

Hi
Anything out more than 1 meter from the windows will cast a shadow. Keeping the rafters as far apart as possible will help to let in the most winter sun.…

Try looking at a Versaline, I have seen it at the Homeshow and it was very easy to remove and all you are left with are a couple of unobtrusive…

I have a 60 cm dual fuel Ilve freestanding cooker and it gets very hot and quickly. It takes about 7 minutes to get to 200 degrees.
If yours is a…

I would be concerned about the cut roof tiles . The tile in the gutter should be a full tile and the cut edge should be concealed under the ridge…